Note: Please check the dimensions are suitable for your requirement before ordering.
Riser chambers to raise the height of your Grease Trap. Each chamber raises your Grease Trap by 320mm including frame for manhole cover. A maximum of 3 chambers can be stacked on top of each other.
- Manufactured in one piece for high strength and rigidity
- Chambers can be stacked up to 3 high to gain required height
- Hole sizes are designed to enable a snug fit
How To Use
- Remove existing lid
- The connecting edge will slide into the top of the grease trap, push firmly down
- Use existing lid to seal riser
If your existing pipe work is situated lower than the outlet of your Grease Trap you are likely to need a riser to raise the level of your fat trap. Riser chambers can be stacked up to a maximum of 3 high, raising the height of your grease trap by up to 920mm (320mm per chamber). Each installation includes one frame (20mm) that your existing Grease Trap lid can be slotted into.
No. of Chambers
Height x Length x Width
320mm x 600mm x 450mm
620mm x 600mm x 450mm
920mm x 600mm x 450mm